Operating The Analyzer; Introduction; Normal Operation - Emerson Rosemount CT5100 Reference Manual

Reference Manual
00809-0100-4511
8

Operating the analyzer

8.1

Introduction

This section describes the normal operation of the analyzer.
NOTICE
The gas concentrations shown in the following screenshots may be different from those
shown in your particular analyzer. The screenshots indicate the functionality of the
software, which is the same regardless of the gases or gas concentrations being measured.
WARNING
BURN HAZARD
Some parts of the analyzer may be heated to 374 °F (190 °C). All components of the
analyzer are hot unless it has been switched off and allowed to cool down. Personal injury
and/or damage to property may result if these safety precautions are not observed. These
precautions are especially important when working at heights.
To prevent burns, do not touch any of the hot parts.
Before fitting, removing, or performing any maintenance on the analyzer, ensure that it
has been switched off and allowed to cool for at least two hours. Before performing any
maintenance on or in the vicinity of the analysis cell, allow the analyzer to cool for at least
twelve hours, as the analysis cell is insulated against heat loss.
When handling the analyzer, always use suitable protective gloves.
If you receive a burn, seek medical treatment immediately.
8.2

Normal operation

The analyzer is designed for long term continuous operation, and therefore its normal
state is to be switched on and performing gas measurements. The analyzer is usually only
switched off for maintenance.
During normal operation, either the Gas Sensor Main screen
Temperature screen
these two screens, press PAGE..
Rosemount CT5100
(Figure 8-2) is shown on the display controller. To toggle between
Operating the analyzer
May 2020
(Figure 8-1) or the Pressure and
69