Emerson Rosemount CT5100 Reference Manual page 5

Safety and information notices
DANGER
WILL CAUSE DEATH
Failure to follow this warning will result in death or serious injury to personnel.
WARNING
DANGER TO PERSONNEL
Failure to follow this warning may result in death or serious injury to personnel.
CAUTION
MAY CAUSE DAMAGE TO EQUIPMENT
Failure to follow this warning may result in damage to the equipment.
NOTICE
Important or tip messages will appear in this format.
Safety precautions
Important
The precautions in this manual MUST NOT be changed amended or removed. All authorized users, installation, operation and
maintenance personnel, must observe the following safety precautions and warnings.
The Rosemount CT5100 analyzer is designed for use in Non Hazardous areas ONLY.
WARNING
ELECTRIC SHOCK
The analyzer operates using mains voltage, which may cause death or serious injury to personnel. Death, personal injury, and/or
damage to persons and/or property may result if this is not observed.
Confirm that the circuit breakers are set to OFF and locked out and tagged out before removing the top cover or opening the front
cover. The analyzer must be earthed.
Only trained, qualified personnel may install and connect power and signal cables. The installation/connection must be in
accordance with all legislative requirements and applicable standards.
Only qualified personnel, familiar with potential risks, should install the analyzer.
DANGER
EXPLOSION HAZARD
Failure to observe this precaution will cause death, personal injury, and/or damage to persons.
The sample gas in the system must be vented to prevent fire or explosion during maintenance and to prevent damage to the
analyzer during prolonged shutdowns.
The sample gas in the pipes leading to the analyzer must be purged for a minimum of 2 minutes and 30 seconds at a minimum
flow rate of 280 L/m at 1.5 ± 0.5 bar to prevent hazards to personnel during maintenance.
Purge the sample gas in accordance with the safe working procedures for this site.
5