Emerson Rosemount CT5100 Reference Manual page 55

Reference Manual
00809-0100-4511
Table 5-4: System Wiring
Terminal Function
19 Digital output 9
20 Digital output 10
21 Digital output 11
22 Digital output 12
23 Analog output 1
24 Analog output 2
25 Analog output 3
26 Analog output 4
27 Analog output 5
28 Analog output 6
29 Analog output 7
30 Analog output 8
31 Status output 1 (Check function)
32 Status output 2 (Maintenance required)
33 Status output 3 (Out of specification)
34 Status output 4 (Failed)
01 Analog or digital input/output
02 Analog or digital input/output
03 Analog or digital input/output
04 Analog or digital input/output
05 Analog or digital input/output
06 Analog or digital input/output
5.4.5 Power input cables and circuit breaker
The power input cable circuit breaker can be tested as follows:
Set the main power circuit breaker to ON.
•
• Check that the display controller lights up. The analyzer will then begin to power-up.
5.4.6 Temperature sensor and cell heater
The sample cell is controlled to operate at a pre-set temperature when it leaves the
factory.
With the analyzer on, the cell will reach the pre-set operating temperature in
approximately 90 minutes.
Rosemount CT5100
(continued)
Install
May 2020
55