Reference Manual
00809-0100-4511
12.5
Replace the TEC board
To replace the TEC board, refer to
Figure 12-4: Replacing the TEC Board
A. TEC board
B. M3 flat washer
C. M3 spring washer
D. M3 x 6 mm socket head cap screw
E. Ribbon cable (to motherboard)
F. Wiring harness (to detector module)
G. Backplate
H. Connector for ribbon cable
Procedure
1. Shut down the analyzer.
2. Open the door of the electrical compartment.
3. Tag or otherwise identify all wiring harnesses before disconnecting.
Rosemount CT5100
Refer to
Shutdown
procedure.
Figure 12-4
and complete the following steps.
Repair and replacement
May 2020
121