Table of Contents
Advertisement
4
Operating the analyzer
4.1
Introduction
This chapter describes the controls, displays, and indicators on the and how to use the
display controller located on the front panel of the instrument.
4.2
Normal operation
The analyzer is designed for long term continuous operation, and therefore its normal
state is to be switched on and performing gas measurements. The analyzer is usually only
switched off for maintenance.
Provided that the start-up procedure described in
analyzer does not require any human intervention during normal operation other than
occasional calibration checks.
During normal operation, either the Gas Sensor Main screen
Temperature screen
these two screens, press .
Figure 4-1:
Quick Start Guide
(Figure
4-2) is shown on the display controller. To toggle between
Gas Sensor Main screen
Operating the analyzer
Chapter 3
has been followed, the
(Figure
4-1) or the Pressure and
35
Advertisement
Table of Contents
