Assembly; Converting The Cast Legs; Removing Stove From Crate - Pacific energy ALT 1.2 Installation And Operating Instructions Manual

1-1/2in
36mm 26-1/2in
675mm
25-1/2in
646mm
24-1/2in
624mm
Shown with standard 6 in. "Short" Legs
Figure 1: Alderlea 1.2 dimensions.

Converting the Cast Legs

• The heater must be installed on either the included 6 inch
(152mm) legs or the optional 8 inch (203mm) legs.
With the stove still on it's pallet, remove the 8 nuts holding the
legs to the unit. remove the "short" legs. (Figure 2)
Place the "Tall" legs under the unit, locating the appropriate
holes in the leg, over the studs provided in the unit's base.
Using the hardware provided, tighten the nuts and washers hand
tight.

Removing stove from crate

• Carefully remove wood top and supports. Remove plastic
cover.
• Using a 7/16" (12mm) wrench, remove lag bolts that
secure hold down brackets to bottom pallet.
• Slide the hold down brackets away from the stove.
5055.7298-A
Dimensions
14-7/8in
378mm
Drawings not shown with adjustable levelling legs.

Assembly

10
3-1/8in
79mm
25-1/8in
639mm
20in
508mm
23-1/8in
588mm
Shown with optional 8 in. "Tall" Legs
Figure 2: Leg bolts location.
27-1/2in
698mm
Leg
mounting
studs
210618-28_ALT 1.2