Flue Collar Conversion - Pacific energy ALT 1.2 Installation And Operating Instructions Manual

Flue collar conversion

The unit comes configured with the flue collar exiting the unit vertically (on top). To Convert to a horizontally exiting flue
collar,
1. Remove the Air Jacket Flue Panel (Figure 3). Remove the round cutout from the center, gently use a screwdriver to
pry it out.
2. Remove the four Top Mounting Screws holding the top to the rear air shield and loosen the two bolts holding the top
to the front crown bracket (under front edge of top on each side). Pull the top forward to release it from the mounting
brackets. Carefully lift up and remove the cast top (Figure 4).
Top Mounting
Screws x4
Figure 4: Flue Conversion Step 2a.
3. Remove the bolts and flue collar from the top of the unit (Figure 6) - Careful do not damage the gasket.
210618-28_ALT 1.2
Figure 3: Flue Conversion Step 1.
Figure 6: Flue Conversion Step 3.
Knockout
Figure 5: Flue Conversion Step 2b.
11
Air Jacket
Flue Panel
mounting
screws x4
5055.7298-A
Top Mounting
Bolt x2