Surround Assembly And Installation - Pacific energy Alderlea T5 LE Insert Installation And Operating Instructions Manual

Surround Assembly and Installation

1. Remove crate and all plastic packaging.
2. Remove Top (A) by lifting up on the front edge and pulling towards you. Caution the Fan Shields (B)
(Figure 11) may fall. Remove Shields by lifting up and to the sides.
3. Remove Surround Top and Sides (porcelian enamel only)- from Packaging.
4. Remove the surround brackets from the stove (Figure 12) and attach to the Surround sides as shown in
Figure 13. Use the bolts and washers in the mounting hardware kit found with the Surround Top (Figure
13).
Figure 11: Removing top and fan shields.
F
Figure 13: Installing brackets on Surround Sides.
5. Using a blanket or cardboard to protect the parts, lay the Surround sides flat on floor and align with
Surround Top(H). Square the surround by aligning edges(I) on each side. Fasten bolts (J) to attach bracket
(Figure 14).
NOTE: If mounting an Oversized Surround (not shown), use mounting holes (K) to attach (Figure 14).
100003038
A
B
F
F
F
Figure 12: Removing the surround bracket.
K
I
J
Figure 14: Securing brackets to surrounds.
20
Fastening
points
Surround
bracket
H
K
J
ALT5 LE Insert 230819-32
I