Assembly; Crate Removal; Pedestal Kit; Leg Kit - Pacific energy pacific vista Operating Instructions Manual

FIG. #1
610mm
159mm
705mm
Pacifi c Vista - Pedestal Model
632mm
156mm
705mm

Assembly

Crate Removal:

1) Carefully remove wood top and supports.
2) Remove plastic cover.
3) Using a 7/16" wrench, remove lag bolts that secure
stove body to bottom pallet.
4) Place stove body carefully on its back.
5) Using a 3/4" wrench, remove 1/2" nuts and save them
for later use.
6) Remove pallet retaining brackets from stove bottom.

Pedestal Kit:

1) With the unit on its back and removable cover facing
up, align the pedestal mounting holes with the studs
on stove bottom.
2) Secure in place with 1/2" nuts previously removed.
3) Carefully place the unit in an upright position.

Leg Kit:

1) With the unit on its back and removable cover of the
ash drawer enclosure facing up, align mounting holes
with studs on stove bottom.
2) Position the legs on the stove.
3) Place the 1/2" washers over the studs and secure in
place with 1/2" nuts previously removed.
4) Carefully place the unit in an upright position.
6
510mm
403mm
145mm
705mm
499mm
403mm
145mm
Vista Classic

Optional Ash Cleanout System:

1) With stove body laying on its back, remove the ash
system hole cover and gasket located under the stove.
Discard cover plate and gasket.
2) Inside the stove, remove the two bolts for the ash dump
from the fi rebox bottom and insert into the brick retainer
with the fl anges on the the brick retainer pointed away
from the threads on the bolts.
3) Replace bolts with brick retainer in the fi rebox
bottom.
4) Place new gasket provided over existing bolts.
5) Install ash dump system over gasket and secure with
two nuts previously removed.
610mm
156mm
Pacifi c Vista - Leg Model
510mm
403mm
145mm
220514-20