MacDon R113 Installation Instructions Manual page 23

H
D C
Figure 3.23: Power Limiter Harness (MD #256651) Installation
4. Connect the power limiter harness (MD #256651) as follows:
• Connect 4-pin male connector (A) to piston pump (B).
• Connect 4-pin female connector (C) to header pump relay harness (D).
• Route power wire with terminal (F) through frame channel hole (E) and connect to bus bar stud (G) beside battery.
Tighten terminal nut to 11 Nm (100 lbf·in).
• Secure harness to chassis harness (H) using cable ties (J) (MD #21763). Locations of module (K) and fuse (L) are
approximate.
215276
INSTALLATION INSTRUCTIONS
C J
J
K
A B
F
G
L
J
E
17
Revision A