MacDon R113 Installation Instructions Manual page 3

Introduction
This kit configures an R113 rotary disc header for an M205 windrower.
IMPORTANT:
The R113 rotary disc header must be configured for an M1170 windrower BEFORE installing this kit.
• If the header does not have a hydraulic motor, install M1170 compatibility kit MD #B6621 before proceeding.
• If the header is configured for M155E4 windrowers, remove the hydraulic motor from the rotary disc header, and install
M1170 compatibility kit MD #B6621 before proceeding. However, do NOT reposition the conditioner drive speed
sensor on the rotary disc header as described in the M1170 kit instructions.
This document explains how to install the kit. A list of parts included in the kit is provided in
Installation time
This kit takes approximately 1 hour to install.
Conventions
The following conventions are used in this document:
• Right and left are determined from the operator's position. The front of the header is the side that faces the crop; the
back of the header is the side that connects to the windrower.
• Unless otherwise noted, use the standard torque values provided in the header operator's manual and technical
manual.
NOTE:
Keep your MacDon publications up-to-date. The most current version of this instruction can be downloaded from our
Dealer-only site (https://portal.macdon.com) (login required).
NOTE:
This document is currently available in English only.
215276
i
2 Parts List, page 4.
Revision A