Attaching The Welding Torch To The Drive Plate - Fronius VR 1500-M Operating Instructions Manual

Attaching the
welding torch to
the drive plate
Attach the strain relief, insert the corrugated hose
Inching in the corrugated hose drive plate side
Attaching the controller
28
(1) (2)
(7)
(9)
1
2
3
4
(3) (4) (5)
5
6
7
8
9
(8)
(6)
Attach the strain relief (1) for the inter-
connecting cable assembly controller
to the controller bracket (2) using Ex-
trude- Tite M5 x 16 screws.
Use a screwdriver to open up the hose
holder (3) on the controller bracket
Insert the corrugated hose (4), close
the hose holder (3).
Use a screwdriver to open up the hose
holder (4) on the drive plate
Insert corrugated hose (5), close hose
holder
Attach cable assembly components:
power cable to connector welding po-
-
tential (3)
control cable (gray) to the controller
-
connector (1)
shielding gas hose to the shielding
-
gas connector (2)
Attach „LocalNet" cable (6) to LocalNet
(7) connector
Attach control cable (8) to drive plate
connector (9)
Use cable ties to fasten cable