Welding-Circuit Inductivity L, Welding-Circuit Resistance R; Stick-Out; Tilt Angle Of The Welding Torch - Fronius TimeTwin Digital Operating Instructions Manual

Welding-circuit In the "TimeTwin Digital" process, the welding-circuit resistance r and welding-
inductivity L,
circuit inductivity L must be aligned separately for each power source.
welding-circuit
resistance r

Stick-out

Wire electrode 1
Stick-out and spacing of the wire electrodes as a function of the diameter of the wire electrode
Tilt angle of the
welding torch
Torch tilt angle: Neutral to slightly leading
72
Contact tube 1
Ø
(1)
90° - 100°
Wire electrode 2
5 - 8 mm
(1)
Set the tilt angle of the welding torch
so that the leading wire electrode (i.e.
the wire electrode of the leading power
source) is held in a neutral to slightly
leading position, depending on the di-
rection of welding.
Gas nozzle
Contact tube 2
Ø
1,0 mm 18 (± 2) mm
1,2 mm 20 (± 2) mm
1,6 mm 22 (± 2) mm
s
1
Leading wire electrode
s
1