Controls, Connections And Mechanical Components; General; Controller - Fronius VR 1500-M Operating Instructions Manual

Controls, connections and mechanical components

General

The location of the controls, connectors, and mechanical components described in the fol-
lowing section can vary depending on customer requirements.
Improper use can cause serious injury and/or material damage.
Do not use the described functions until you have read and understood the following doc-
umentation:
► this Operating Manual
► any and all Operating Manuals for the system components, especially the safety guide-

Controller

Front View
(1)
(2)
(3)
(4)
(5)
(6)
(7)
(8)
(9)
WARNING!
lines
(1)
Gas check key
used to set the required gasflow at the pressure reducer. Press the key and hold
down to allow gas to escape.
Inching key
use to inch the wire electrode into the torch cable assembly with the system in a
gasless, zero-current state.
Cover (unused)
Connector Robacta robot welding torch (14 pin)
Cover (unused)
Connector LocalNet
standard 10 pin socket for system extensions (e.g. remote control, etc.)
Connector LocalNet - interconnecting cable assembly (10 pin)
Connector drive plate - 17 pin female centronics conector
Cover (unused)
(2)
(6)
(3)
(4)
(5)
Rear View
(7)
(8)
(9)
23