Step 4: Install The Module - Keysight M9203A Startup Manual

Step 4: Install the Module

PXI hardware does not support "hot-swap" operation. Before installing the
module into the chassis, power off the chassis to prevent damage to the module.
1. Make sure the chassis is connected to the main supply, but power switch is in
the Off (Standby) position.
2. If the chassis has multiple fan speed settings, ensure that the fans are set to
automatic. Do not set the fan speed to low or turn it off.
3. Position the chassis so that there is ample space between the chassis fan
intake and exhaust vents.
4. If using a remote controller, install the System Interface Card in the slot iden-
tified by the triangle symbol:
5. Install the module into the appropriate slots of the chassis by placing the mod-
ule card edges into the front module guides (top and bottom). Ensure that the
ejector handle is pushed down and slide the module to the rear.
6. When resistance is felt, latch the module by pulling up on the ejector handle.
7. Tighten the screws on the module front panel. Performance may suffer if the
screws are not tightened.
8. Verify that the chassis fans are operable and free of dust and other con-
taminants that may restrict airflow.
Keysight M9203A Startup Guide
The module can be installed in any PXIe slot marked with a peripheral slot com-
patibility image (a circle containing the slot number).
The module can also be installed in any hybrid PXIe slot marked with a peripheral slot
compatibility image (the letter "H" and a solid circle containing the slot number).
Installing a module into a PXI chassis
Step 4: Install the Module
15