Error occurred in the ITB Unit.
Solution
1.
Remove the ITB unit, and check the steering control unit.
If a wire is disconnected, connect it again.
If mechanical parts are deformed, replace them.
2.
Replace the electrical components.
Belt centering motor (STM2)
Belt centering roller HP sensor (SEN3)
3.
Replace the ITB Unit.
SC471-04, 05
Error Name
471-04: Image Transfer Belt Position Error 2
471-05: Image Transfer Belt Position Error 3
Pattern
D
Error Condition
471-04: This SC occurs when the image transfer belt shifts too much to the front side of the
machine.
471-05: This SC occurs when the image transfer belt shifts too much to the rear side of the
machine.
Major Cause
Image transfer belt is worn out (stretched or distorted)
There is increased load on the belt due to fault or defect in units adjacent to the image transfer belt.
Steering control unit is defective (wire disconnected or parts deformed).
Electrical components are defective:
Belt centering motor (STM2)
Belt centering roller HP sensor (SEN3)
Belt centering sensor (SEN96)
Error occurred in the ITB Unit.
Solution
1.
Perform the procedure in
If the SC reoccurs go on to Steps 2 to 5.
2.
Resolve excess load of units adjacent to the image transfer belt (drum, PTR unit, ITB cleaning
unit).
ITB Centering: SC471-03, -04, -05, -06 (ITB Position
1.SC Codes
Errors).
79