No Feeding; Excessive Shift Or Skew, Image Skew On Paper - Ricoh Pro 8300S Troubleshooting Manual

No Feeding

This problem is caused by a variety of factors.
If no feeding persists, try feeding again from the paper tray of the main machine, instead of the

vacuum feed LCIT
1. Remove the paper from the paper tray and fan the paper. Problem solved?
Yes
No
2. Attach the tab sheet holder.
Yes
No
3. Clean the feed unit. Problem solved?
Yes
No
4. Create a new custom paper setting.
5. In Advanced Settings, set 36: [Paper Feed Mode (Adjust Fan Level)] to "Moderate Nonfdg Red.
(Higher)". Problem solved?
Yes
No
6. In Advanced Settings, set 36: [Paper Feed Mode (Adjust Fan Level)] to "Max Nonfdng Reduc.
(Highest)". Problem solved?
Yes
No
7. In Advanced Settings, change 40: [Switch Paper Load Upper Limit] from [Low] (18mm) to [High]
(12mm). Problem solved?
Yes
No
8. Manually adjust the paper load upper limit. Problem solved?
Yes
No
9. Clean the paper feed belt.

Excessive Shift or Skew, Image Skew on Paper

1. Is paper type less than Thick 3?
Yes Go to next step.
No Problem cannot be corrected in the field.
2. Create a new custom paper setting.
3. In Advanced Settings, change 40: [Switch Paper Load Upper Limit] from [Low] (18mm) to [High]
Finished.
Go to next step.
(Attaching the Tab Holder) Problem solved?
Finished.
Go to next step.
Finished.
Go to next step.
Finished.
Go to next step.
Finished.
Go to next step.
Finished.
Go to next step.
Finished.
Go to next step.
(Cleaning the Paper Feed
4.Troubleshooting for Peripheral Units
Belt)
815