Sc756-51; Ring Binder: Output Belt Hp Error - Ricoh Pro 8300S Troubleshooting Manual

Solution
1. Turn the power OFF and ON.
2. Check the connector.
Check the connection between the swing motor/swing HP sensor with the main board. (Check all
the connectors are completely connected.)
If the connector is disconnected, reconnect the connector. Turn the power OFF/ON, and then
check if the SC recurs.
3. Check the harness.
Check if the harness between the swing motor/swing HP sensor with the main board is damaged or
exposed. If so, replace the harness. Turn the power OFF/ON, and then check if the SC recurs.
4. Replace the components.
Replace the swing motor.

Replace the swing HP sensor.

 Replace the main board.

SC756-51

Error Name

Ring Binder: Output Belt HP Error

Pattern
B
Error Condition
 The output belt moved from home position, but home position is detected even after a specified
time had passed. (The first time is reported as a jam. An SC is issued the second time this occurs.)
The output belt has moved to the home position, but home position is not be detected within a

specified time. (The first time is reported as a jam. An SC is issued the second time this occurs.)
*First time jam: Exit belt jam (J339)
Major Cause
 Power of downstream unit not turned on
Output belt motor defective

Connector disconnected

Overload

Output belt HP sensor defective

Solution
1. Turn the power OFF and ON.
1.SC Codes
577