Tsi Print; When There Is No Paper Of The Correct Size - Ricoh 185 Operating Instructions Manual

Note
By default this feature is turned
off. Switch it on with the User Pa-
rameters. ⇒ P.184 "Changing the
User Parameters"
Reference
P.57 "Page Separation and Length Re-
duction (not available in some coun-
tries)"

TSI Print

Usually the sender's TTI is printed on
received messages. If the sender has

When There is No Paper of the Correct Size

If there is no paper in your machine that matches the size of a received message,
the machine will choose a paper size based upon the paper you have available.
For example, if your machine has LG (8.5 × 15") L installed and you receive an
LT (8.5 × 14") L size message, check the LT column of the table below. The pa-
per size at the top has the highest priority. In this case, since LG (8.5 × 14") L is
higher priority than DLT (11 × 17") K, the message is printed on LG (8.5 × 14")
L.
Priority Table
Page Reduction
Reduction in Sub-scan Direction
Page Separation Threshold
Width or Length Priority
not programmed their TTI, you will
not be able to identify them. Howev-
er, if you turn this feature on, the
sender's RTI P.156 "RTI/TTI" or CSI
P.156 "RTI/TTI" is printed instead so
you can find out where the message
came from.
Note
You can turn it on or off with the
User Parameters. ⇒ P.184 "Chang-
ing the User Parameters"
Disabled
Enabled
20 mm
Width
PRINTING FUNCTIONS
3
59