Management Ports; Rj45 Console Port Access - Dell EMC PowerSwitch N2200-ON Series Installation Manual

The N2200-ON Series switch provides three ports for management and one USB flash drive mount for file transfers.
NOTE: The output examples in this section are for reference only. Your output may vary.
Topics:
•

RJ45 console port access

• MicroUSB Type-B console port access
• USB storage mount
RJ45 console port access
For the N2200-ON Series switch, the management ports are on the I/O-side of the switch.
N2224PX-ON and N2224X-ON management ports
1. Out-of-band management port (right), RJ45 console port (left)
N2248PX-ON and N2248X-ON management ports
1. Out-of-band management port (right), RJ45 console port (left)
NOTE: Ensure that any equipment that is attached to the serial port can support the required 115200 baud rate.
NOTE: If the serial port of your computer cannot accept a female DB-9 connector, use a DB-9 to USB adapter.
NOTE: When connecting the RJ45 console to the patch panel or terminal server using Cat5e or Cat6 Ethernet cables,
the maximum cable length is 100m. However, if the Ethernet cable is disconnected from the patch panel or terminal
server but connected to the RJ45 console, the maximum cable length is 6m. If the cable is longer than 6m when
disconnected from the panel or server, your switch may not boot.
1. Install the provided RJ45 connector-side of the provided cable into the switch console port.
2. Install the DB-9 female-side of the provided copper cable into the serial port of your computer.
46

Management ports

Management ports
7