Pump Control Panel Setup And Operation; Manifold And Pump Installation - Nordson Encore HD Powder Spray System with Prodigy Color-on-Demand Customer Product Manual

Table of Contents

4-2

Operation

Pump Control Panel Setup and Operation

Figure 4-1 Pump and Manifold Installation

1. Mounting screws (2)

2. Pump

Part 1605396-04

To install a pump and manifold into an existing pump panel:

1. See Figure 4-1. Make sure that the gaskets on the pump (2) and

manifold (5) are not damaged. If the gaskets are damaged, replace

them.

2. Set the manifold onto the appropriate mounting bracket (4) against the

pump panel wall (3). Secure the manifold with the mounting screws (6),

but do not tighten the screws.

3. Secure the pump to the pump panel and manifold using the pump

mounting screws (1). Tighten the pump mounting screws securely.

4. Tighten the manifold mounting screws securely.

5. Perform the Calibration procedure on page 4-7.

3. Pump panel wall

4. Manifold mounting bracket

5. Manifold

6. Manifold mounting screws (2)

E 2018 Nordson Corporation

Table of Contents

Do you have a question about the Encore HD Powder Spray System with Prodigy Color-on-Demand and is the answer not in the manual?