Color-On-Demand Controller And Foot Switch Connections - Nordson Encore HD Powder Spray System with Prodigy Color-on-Demand Customer Product Manual

3-8
Installation

Color-on-Demand Controller and Foot Switch Connections

Part 1605396-04
1. Connect the power cables to the Color-on-Demand controllers.
2. Cut one of the RJ45 jacks off the 100 ft. long Ethernet cable included in
the ship-with kit, leaving a jack on the other end.
3. Remove the back from the controller and plug the Ethernet cable into
the socket as shown.
4. Pull the cut end of the cable through the provided 1/2 in. conduit
connector and conduit to the color panel and route it inside the panel.
5. Connect the cable leads to the termination module as shown on
page 3-10.
6. Connect the conduit to the controller and panel.
7. If you are going to use the foot switches, remove the bottom covers and
install the provided connectors. Connect 6-mm tubing from the
FOOTSWITCH A & B fitting to the IN fitting on the switch, and from the
OUT fitting to the SWA RTN or SWB RTN ports on the tubing manifolds.
E 2018 Nordson Corporation