Installation; Setup And Installation Checklist; Get Ready; Configure The Matrix Switcher - Extron electronics FOX3 Matrix 80x User Manual

Installation

This section details the installation and configuration of the FOX3 matrix switchers, including:
•
•

Setup and Installation Checklist

Get Ready

…
…

Configure the Matrix Switcher

…
…
…

Perform Physical Installation

…
…
…
…
…
Setup and Installation Checklist
Rear Panel Boards, Cabling, and Features
Familiarize yourself with the FOX3 matrix switcher.
Obtain IP setting information for the matrix switcher from the local network administrator
(see Network Settings Panel
Install the desired I/O boards (see
page 48).
Install the Product Configuration Software (PCS) (see
on page 30).
(Optional) Upload a System Map (see the FOX3 Matrix PCS Help File).
If desired, install the switcher in a rack (see
Cable input and output devices to the I/O boards (see
and Features on page 7).
If desired, connect computers or control systems to any of the remote control ports on
the switcher
• Rear panel Remote RS-232 serial port (see
• Rear panel LAN port (see
Front panel USB Configuration port (see
•
page 17).
Power
Connect power (see
Test the switcher by creating a tie (see
on page 43).
Removing and Installing an I/O Module
Software/Firmware Installation
Mounting the Switcher
Rear Panel Boards, Cabling,
Remote Port
Ethernet (LAN) Port on page 18).
Front Panel Configuration Port
on page 13).
Output switching
FOX3 Matrix 80x Switchers • Installation
on
on page 47 ).
on page 10).
on
on page 24).
6