Table of Contents
Advertisement
4. Setting options on the display level
The display level provides the following setting options that are only effective for a certain time:
If the current room temperature is too warm or too cold, you can override the controller
setting.
If you would like to prevent the controller from switching over to the reduced mode (for
example, due to a party or public holiday) and continue heating, you can set the control-
ler to Party mode.
If you would like to switch off the heating for longer periods of time (for example, vaca-
tion), you can set the controller to Holiday mode.
4.1 Short-term change in room temperature
If you change the preset reference value for room temperature or set point for flow temperature,
this change remains effective until the next time-of-use or time of non-use comes into effect.
When the weather-compensated control is activated, the reference value for room tempera-
4.2 Party mode
ture appears in the display or when the fixed set point con-
trol is activated, the set point for flow temperature appears
on the left-hand side of the display.
Turn the control knob clockwise or counterclockwise one
position,
after a brief interval, the clock and sun symbols start to
blink.
You can now set the reference value for room temperature
or the set point for flow temperature to the required value.
Press the knob to acknowledge the setting.
Alternatively, you can wait three seconds until the display
stops blinking. The new value is stored.
If you would like to continue heating in rated operation, yet
this deviates from the time schedule, you can achieve this
as follows:
Turn the control knob clockwise until PArtY appears in the
display.
Press the knob to acknowledge the setting.
Setting options on the display level
EB 5432-1 EN
9
Advertisement
Table of Contents
