Sis Configuration And Control; Host Device Connection; Sis Programming Guide; Host-To-Device And Device-To-Host Communication - Extron electronics XTP T HWP 101 User Manual

SIS Configuration
and Control
The XTP T HWP 101 can be configured and controlled using Extron Simple Instruction
Set (SIS) commands or the XTP System Configuration Software (see
Configuration Software
details and SIS commands and responses when connected directly to the XTP T HWP 101.
Topics in this section include:
•
•
•

Host Device Connection

Use a connected computer running the Extron DataViewer utility to send and receive
SIS commands and responses. To connect directly to an XTP T HWP 101, connect the
computer to the XTP T HWP 101 through the rear panel USB Config port.

SIS Programming Guide

Host-to-Device and Device-to-Host Communication

SIS commands consist of one or more characters per field. No special characters are
required to begin or end a command sequence. When the XTP T HWP 101 determines that
a command is valid, it executes the command and sends a response to the host device. All
responses from the transmitter to the host end with a carriage return and a line feed
(CR/LF = ]), which signals the end of the response character string. A string is one or more
characters.

Error Responses

When the XTP T HWP 101 receives an SIS command and determines that it is valid, it
performs the command and sends the corresponding response to the host device. If the
command is determined invalid or contains invalid parameters, the transmitter returns an
error response to the host. The error response codes are:
E10
E13
E14
E17
E22
on page 21). This section contains basic SIS communication
Host Device Connection
SIS Programming Guide
Command and Response Tables for SIS Commands
= Invalid command
= Invalid parameter
= Not valid for this configuration
= Invalid command for signal type
= Busy
XTP T HWP 101 Wallplate Transmitter • SIS Configuration and Control
XTP System
18