H3C SR6600 Configuration Manual page 22

To do...
Set the PVC's
service type to
variable bit
rate-real time
(rt_VBR), and set
the rate-related
parameters
Configure IPoA
and enable inverse
address resolution
Configure
(InARP) for the
the service
PVC
type (use
different
commands
according to
service
types)
Establish PPPoA
mapping for the
PVC
Establish IPoEoA
or PPPoEoA
mapping for the
PVC
Quit to system view
Enter ATM Enter ATM
interface interface view
view or PVC
Enter PVC view
view
Enable the ATM class on the
interface or PVC
When configuring a PVC, note that:
The priorities of the same configurations performed to a PVC descend in this order: the
configuration directly performed to the PVC, the configuration performed to the ATM class applied
to the PVC, and the configuration performed to the ATM class applied to the ATM interface.
For different configurations that conflict with each other, their priorities descend in this order: the
configuration directly performed to the PVC, the configuration performed to the ATM class applied
to the PVC, and the configuration performed to the ATM class applied to the ATM interface.
All the configurations that are directly performed to the PVC, performed to the ATM class applied to
the PVC, and performed to the ATM class applied to the ATM interface take effect if they do not
conflict.
For different configurations performed to a PVC, the ATM class applied to the PVC, and the ATM
class applied to the ATM interface, if the configurations conflict with each other, those applied first
take effect, and the conflict prompt appears when the rest are performed.
When an ATM class is applied to a PVC, no message is prompted no matter whether or not the
ATM class is successfully applied.
Use the command...
service vbr-rt output-pcr
output-scr output-mbs
map ip inarp [ minutes ]
[ broadcast ]
map ppp virtual-template
vt-number
map bridge virtual-ethernet
interface-number
quit
interface atm { interface-number |
interface-number.subnumber }
pvc { pvc-name [ vpi/vci ] | vpi/vci }
atm-class atm-class-name
1-12
Remarks
Optional
By default, mapping is not
configured. When a mapping is
configured, pseudo-broadcast is
not supported by default.
Before configuring InARP, make
sure the aal5snap encapsulation is
used. Though InARP is also
supported when using aal5mux or
aal5nlpid encapsulation, the
system will prompt a message
indicating a failure when this ATM
is configured and used on PVC.
Optional
Optional
—
Required
Required
Required