Configuring Pppoeoa - H3C SR6600 Configuration Manual

When you configure a static route for a virtual template interface, you are recommended to specify the
next hop rather than the outgoing interface. If you want to specify the outgoing interface, make sure the
physical interface bound to the virtual template is valid to ensure correct transmission.

Configuring PPPoEoA

PPPoE adopts the Client/Server model. It encapsulates PPP packets into Ethernet frames and provides
point-to-point connection on Ethernet. The following configurations enable the PVC to carry PPPoE and
configure a PPPoE mapping for the PVC.
Follow these steps to configure PPPoEoA:
To do...
Enter system view
Create a VT interface
Set the PPP authentication mode
and IP address; with the PPPoE
server, an address pool should be
configured to allocate IP address
for the peer end; with the PPPoE
client, address negotiation should
be configured to accept the IP
address allocated by the server
end.
Quit to system view
Create a VE interface
Configure PPPoE parameters on
VE interface (the configuration
differs when with a PPPoE server
and when with a PPPoE client)
Quit to system view
Enter ATM interface view
Create PVC, and enter PVC view
Create PPPoEoA mapping for
PVC
Use the command...
system-view
interface virtual-template
vt-number
For more information, see PPP in
the Layer 2 – WAN Configuration
Guide.
quit
interface virtual-ethernet
interface-number
For more information, see PPP in
the Layer 2 – WAN Configuration
Guide.
quit
interface atm { interface-number |
interface-number.subnumber }
pvc { pvc-name [ vpi/vci ] | vpi/vci }
map bridge virtual-ethernet
interface-number
1-16
Remarks
—
Required
You must configure PPP
authentication and an IP address
on the VT interface (the IP address
is invalid if configured on the ATM
interface).
Required
—
Required
Required
—
—
Required
Required
The interface-number argument
refers to the VE interface created in
the above steps.