Configuring Ipoeoa - H3C SR6600 Configuration Manual

To do...
Configure an IPoA mapping for the
PVC, and enable the PVC to carry
IP packets
If you execute the map ip command with the broadcast keyword, which specifies pseudo
broadcast, any broadcast packets received by the port on which the PVC is created will be
duplicated to the PVC. Therefore, to propagate broadcast/multicast packets on an ATM PVC with a
broadcast or multicast protocol enabled, you must specify the broadcast keyword.
On PVCs created on P2P ATM subinterfaces, you must configure the map ip default broadcast
command.

Configuring IPoEoA

Follow these steps to configure IPoEoA on a PVC:
To do...
Enter system view
Create a virtual Ethernet (VE)
interface
Quit to system view
Enter ATM interface view
Create PVC and enter its view
Configure IPoEoA mapping on the
PVC
Use the command...
map ip { ip-address [ ip-mask ] |
default | inarp [ minutes ] }
[ broadcast ]
Use the command...
system-view
interface virtual-ethernet
interface-number
quit
interface atm { interface-number |
interface-number.subnumber }
pvc { pvc-name [ vpi/vci ] | vpi/vci }
map bridge virtual-ethernet
interface-number
1-14
Remarks
Required
By default, no mapping is
configured. If a mapping is
configured, pseudo-broadcast is
not supported by default.
Before configuring InARP, make
sure that aal5snap encapsulation
is used. InARP is not supported
when aal5mux or aal5nlpid
encapsulations is adopted.
Remarks
—
Required
The IP address has to be
configured on a VE interface (It is
invalid to configure the IP address
on the ATM interface).
—
—
Required
Required