Configuring Pppoa - H3C SR6600 Configuration Manual

When multiple Layer-3 virtual Ethernet interfaces are connected through PVCs to a DHCP server
that assigns IP addresses to the interfaces through static address binding, you must configure
different MAC addresses for the interfaces with the mac-address command. For more information,
see Ethernet Interface in the Interface Configuration Guide.
In an IPoEoA application, Class Based Queuing (CBQ) should be configured on PVCs.

Configuring PPPoA

When two routers are connected using DSL interfaces through a dial-up connection, configure them as
PPPoA server and client respectively. The two are different in that, with the PPPoA server, you should
configure an address pool to allocate an IP address for the remote node; with the PPPoA client, you
should configure address negotiation to accept the IP address allocated by the server end. For more
information, see PPP in the Layer 2 – WAN Configuration Guide.
The following configurations enable the PVC to carry PPP and configure a PPP mapping for the PVC.
Follow these steps to configure PPPoA:
To do...
Enter system view
Create a VT interface
Set the PPP authentication mode
and IP address; with the PPPoE
server, an address pool should be
configured to allocate an IP
address for the remote end; with
the PPPoE client, address
negotiation should be configured to
accept the IP address allocated by
the server end
Quit to system view
Enter ATM interface view
Create PVC, and enter PVC view
Configure PPPoA mapping for the
PVC
Use the command...
system-view
interface virtual-template
vt-number
For more information, see PPP in
the Layer 2 – WAN Configuration
Guide.
quit
interface atm { interface-number |
interface-number.subnumber }
pvc { pvc-name [ vpi/vci ] | vpi/vci }
map ppp virtual-template
vt-number
1-15
Remarks
—
Required
You must configure PPP
authentication and IP address on
the VT interface (the IP address is
invalid if configured on the ATM
interface).
Required
—
—
Required
Required