Ipoeoa Configuration Example - H3C SR6600 Configuration Manual

# Establish a PVC that carries IP packets.
[RouterB-Atm1/0/1] pvc to_a 0/0/50
[RouterB-atm-pvc-Atm1/0/1-0/0/50-to_a] map ip 202.38.160.1
[RouterB-atm-pvc-Atm1/0/1-0/0/50-to_a] quit
[RouterB-Atm1/0/1] pvc to_c 0/0/51
[RouterB-atm-pvc-Atm1/0/1-0/0/51-to_c] map ip 202.38.160.3
3) Configure Router C
# Enter the ATM interface, and configure an IP address for it.
<RouterC> system-view
[RouterC] interface atm 1/0/1
[RouterC-Atm1/0/1] ip address 202.38.160.3 255.255.255.0
# Establish a PVC and specify it to carry IP.
[RouterC-Atm1/0/1] pvc to_a 0/0/60
[RouterC-atm-pvc-Atm1/0/1-0/0/60-to_a] map ip 202.38.160.1
[RouterC-atm-pvc-Atm1/0/1-0/0/60-to_a] quit
[RouterC-Atm1/0/1] pvc to_b 0/0/61
[RouterC-atm-pvc-Atm1/0/1-0/0/61-to_b] map ip 202.38.160.2

IPoEoA Configuration Example

Network requirements
As shown in Figure
network through an ADSL Router, and they communicate with router C via DSLAM. The requirements
are:
The IP address of the VE interface of Router C is 202.38.160.1;
The VPI/VCI value of two PVCs connecting route C and DSLAM are 0/0/60 and 0/0/61, pointing to
Router A and Router B respectively.
Both the WAN port of Router C and the DSL interfaces of the ADSL Routers adopt IPoEoA.
Figure 1-4 Network diagram for IPoEoA configuration
Configuration procedure
Configure Router C:
# Create a VE interface and configure an IP address for it.
<RouterC> system-view
[RouterC] interface virtual-ethernet 1
1-4, each of the hosts in the two Ethernets is respectively connected to the ATM
1-19