H3C SR6600 Configuration Manual page 70

[RouterB-luser-rta] service-type ppp
[RouterB-luser-rta] quit
# Create an Mp-group interface and assign an IP address to it.
[RouterB] interface mp-group 1
[RouterB-Mp-group1] ip address 111.1.1.2 24
[RouterB-Mp-group1] quit
# Configure Serial 2/0/2.
[RouterB] interface serial 2/0/2
[RouterB-Serial2/0/2] link-protocol ppp
[RouterB-Serial2/0/2] ppp authentication-mode pap domain system
[RouterB-Serial2/0/2] ppp pap local-user rtb password simple rtb
[RouterB-Serial2/0/2] ppp mp mp-group 1
[RouterB-Serial2/0/2] shutdown
[RouterB-Serial2/0/2] undo shutdown
[RouterB-Serial2/0/2] quit
# Configure Serial 2/0/1.
[RouterB] interface serial 2/0/1
[RouterB-Serial2/0/1] link-protocol ppp
[RouterB-Serial2/0/1] ppp authentication-mode pap domain system
[RouterB-Serial2/0/1] ppp pap local-user rtb password simple rtb
[RouterB-Serial2/0/1] ppp mp mp-group 1
[RouterB-Serial2/0/1] shutdown
[RouterB-Serial2/0/1] undo shutdown
[RouterB-Serial2/0/1] quit
# Configure the users in the domain to use the local authentication scheme.
[RouterB] domain system
[RouterB-isp-system] authentication ppp local
[RouterB-isp-system] quit
# Verify the configuration on Router A.
[RouterA] display ppp mp
Mp-group is Mp-group1
Bundle Multilink, 2 member, Master link is Mp-group1
0 lost fragments, 0 reordered, 0 unassigned, 0 interleaved,
sequence 0/0 rcvd/sent
The bundled member channels are:
Serial2/0/1
Serial2/0/1
# Check the state of Mp-group1.
[RouterA] display interface Mp-group 1
Mp-group1 current state : UP
Line protocol current state : UP
Description : Mp-group1 Interface
The Maximum Transmit Unit is 1500, Hold timer is 10(sec)
Internet Address is 111.1.1.1/24
Link layer protocol is PPP
LCP opened, MP opened, IPCP opened, MPLSCP opened
Physical is MP
Output queue : (Urgent queue : Size/Length/Discards)
Output queue : (FIFO queuing : Size/Length/Discards)
0/500/0
0/75/0
2-60