H3C SR6600 Configuration Manual page 46

The router operating as the server: In this case, you need to configure a local IP address pool in
domain view or system view to specify the range of the IP addresses to be allocated, and then bind
the address pool to the interface.
3) DNS address negotiation
PPP address negotiation can also determine the DNS server address. You can configure the router to
allocate the DNS server address to the peer or receive the DNS server address from the peer. Normally,
for a PPP link between a PC and the router, the DNS server address is usually allocated by the router,
through which the PC can access the Internet directly using domain names. For a PPP link established
between the router and the access server of a carrier, the DNS server address is usually allocated by
the access server, through which the router can resolve domain names through the DNS server
address allocated by the access server.
Configuring the PPP negotiation timeout time
Follow these steps to configure PPP timeout time:
To do...
Enter system view
Enter interface view
Configure the negotiation timeout
time
Configuring IP address negotiation
Follow these steps to configure IP address negotiation:
To do...
Enter system view
Enter interface view
Configure IP
address negotiation
1) Configuring the local end as the client
Follow these steps to configure the local end as the client:
To do...
Enter system view
Enter interface view
Enable IP address negotiation
2) Configuring the local end as the server
Follow these steps to configure the local end as the server (for scenarios where PPP authentication is
not enabled):
Use the command...
system-view
interface interface-type
interface-number
ppp timer negotiate seconds
system-view
interface interface-type
interface-number
Configure the local See
end as the client as the client
Configure the local See
end as the server as the server
Use the command...
system-view
interface interface-type
interface-number
ip address ppp-negotiate
Use the command...
1) Configuring the local end
2) Configuring the local end
2-36
Remarks
—
—
Optional
3 seconds by default
Remarks
—
—
Either of the two is required.
Remarks
—
—
Required