H3C SR6600 Configuration Manual page 50

To do...
Create a VT interface and enter VT
interface view
Set the maximum number of links that
can be used for transmitting multicast or
broadcast packets supported on the
virtual template
Quit to system view
Associate a
physical interface
or a username to
the VT interface
(use either method)
Configure other MP parameters
Configuring other optional parameters
Follow these steps to configure other optional parameters:
To do...
Enter system view
Create an MP VT interface or enter
dialer interface view
Set the binding mode
Set the maximum number of links
allowed in an MP bundle
interface virtual-template number
broadcast-limit link number
quit
interface interface-type
interface-number
Associate a
ppp mp virtual-template number
physical interface
to the virtual
template interface
Configuration PPP authentication.
See section
ppp mp user username bind
virtual-template number
interface interface-type
interface-number
Associate a
username to the
VT interface
ppp mp
Configure two-way PPP
authentication. See
PPP.
See
parameters.
Use the command...
system-view
interface virtual-template
number
interface dialer number
ppp mp binding-mode
{ authentication | both |
descriptor }
ppp mp max-bind max-bind-num
Use the command...
Configuring PPP.
Configuring
Configuring other optional
2-40
Remarks
Required
Optional
Default to 30.
—
—
Required
Specify the number of the VT
interface the interface to be
bound to.
Optional
PPP authentication has no
effect on the setup of MP
Required
Associate a VT interface to
MP users.
—
Required
Configure the interface
encapsulated with PPP to
operate in MP mode.
Required
Optional
Remarks
—
Required
The interface virtual-template
command also leads you to VT
interface view.
Optional
By default, MP binding is based on
both the PPP authentication
username and the descriptor.
Optional
16 by default.
This command is available in VT
interface view and dialer interface
view.