H3C SR6600 Configuration Manual page 68

# Configure the user in the domain to use the local authentication scheme.
[RouterB] domain system
[RouterB-isp-system] authentication ppp local
[RouterB-isp-system] quit
# Verify the configuration on Router A.
<RouterA> display ppp mp
Template is Virtual-Template1
Bundle rtb, 2 member, Master link is Virtual-Template1:0
0 lost fragments, 0 reordered, 0 unassigned, 0 interleaved,
sequence 0/0 rcvd/sent
The bundled member channels are:
Serial2/0/2
Serial2/0/1
# Verify the results on Router B.
[RouterB] display ppp mp
Template is Virtual-Template1
Bundle rta, 2 member, Master link is Virtual-Template1:0
0 lost fragments, 0 reordered, 0 unassigned, 0 interleaved,
sequence 0/0 rcvd/sent
The bundled member channels are:
Serial2/0/2
Serial2/0/1
# Check the information about the virtual access interface.
[RouterB] display virtual-access
Virtual-Template1:0 current state : UP
Line protocol current state : UP
Description : Virtual-Template1:0 Interface
The Maximum Transmit Unit is 1500
Link layer protocol is PPP
LCP opened, MP opened, IPCP opened, OSICP opened, MPLSCP opened
Physical is MP
Output queue : (Urgent queue : Size/Length/Discards)
Output queue : (FIFO queuing : Size/Length/Discards)
5 minutes input rate 0 bytes/sec, 0 packets/sec
5 minutes output rate 0 bytes/sec, 0 packets/sec
21 packets input, 1386 bytes, 0 drops
21 packets output, 1386 bytes, 0 drops
# Ping the IP address 8.1.1.1 on Router B.
[RouterB] ping 8.1.1.1
PING 8.1.1.1: 56
Reply from 8.1.1.1: bytes=56 Sequence=1 ttl=255 time=29 ms
Reply from 8.1.1.1: bytes=56 Sequence=2 ttl=255 time=31 ms
Reply from 8.1.1.1: bytes=56 Sequence=3 ttl=255 time=30 ms
Reply from 8.1.1.1: bytes=56 Sequence=4 ttl=255 time=31 ms
Reply from 8.1.1.1: bytes=56 Sequence=5 ttl=255 time=30 ms
--- 8.1.1.1 ping statistics ---
5 packet(s) transmitted
5 packet(s) received
data bytes, press CTRL_C to break
0/500/0
0/75/0
2-58