Displaying And Maintaining Ssh; Stelnet Configuration Examples; Password Authentication Enabled Stelnet Server Configuration Example - H3C S5830V2 Security Configuration Manual

Displaying and maintaining SSH

Execute display commands in any view.
Task
Display the source IP address or source
interface information configured for the SFTP
client.
Display the source IP address or source
interface information configured for the Stelnet
client.
Display SSH server status information or session
information on an SSH server.
Display SSH user information on the SSH
server.
Display the public keys of the local key pairs.
Display the public keys of the SSH peers.

Stelnet configuration examples

This section provides examples of configuring Stelnet.
Unless otherwise noted, devices in the configuration examples are in non-FIPS mode.
Password authentication enabled Stelnet server configuration
example
Network requirements
As shown in
assigned the user role network-admin for configuration management. The switch acts as the Stelnet server
and uses password authentication. The username and password of the client are saved on the switch.
Figure 46 Network diagram
Stelnet client
192.168.1.56/24
Host
Configuration procedure
1. Configure the Stelnet server:
# Generate the RSA key pairs.
<Switch> system-view
[Switch] public-key local create rsa
Figure 46, you can log in to the switch through the Stelnet client that runs on the host and are
Vlan-int2
192.168.1.40/24
Command
display sftp client source
display ssh client source
display ssh server { session | status }
display ssh user-information [ username ]
display public-key local { dsa | rsa } public [ name
publickey-name ]
display public-key peer [ brief | name publickey-name ]
Stelnet server
Switch
176