Sonarpro Workstation Controls And Indicators - Klein 5000 V2 Series Operation And Maintenance Manual

Topside System Controls and Indicators
T/F POWER:
TOWFISH AWAKE:
TOWFISH DOWNLINK:
TOWFISH UPLINK:
STATUS TRIGGER:
STATUS RESPONDER:
STATUS ERROR:
3.7.2

SonarPro Workstation Controls and Indicators

Most of the SonarPro Workstation controls and indicators are on the SonarPro
Workstation front panel which is shown is Figure 3-4. Also shown is the location
of the DVDRW optical drive.
The SonarPro Workstation controls and indicators are the following:
ON/OFF switch:
HARD DRIVE ACTIVITY:
ETHERNET:
POWER:
POWER switch:
RESET switch:
Blue LED that is on when power is being applied to
the towfish.
Green LED that is on when the towfish is powered
and is acquiring data.
Green LED that is on when commands are being
transfered from the TPU to the towfish.
Green LED that is on when data are being transfered
from the towfish to the TPU.
Yellow LED that flashes when the sonar on the
towfish transmits.
Yellow LED that flashes when a responder trigger is
sent to the towfish.
Red LED that flashes if system errors are detected.
Rocker switch/circuit breaker that switches AC
power to the SonarPro Workstation and provides AC
input current protection. This switch/circuit breaker,
which is on the back panel and is shown in
Figure 3-2 on page 3-9, should be left in the ON
position. Should the breaker trip, the switch/circuit
breaker will switch to the OFF position. To reset it,
switch it to the ON position.
Green LED that flashes when the hard drive is being
accessed.
Green LED that flashes when there is activity on
Ethernet port.
Blue LED that is on when the SonarPro Workstation
is on.
Push button switch that turns the SonarPro
Workstation on or off.
Push button switch that resets the SonarPro
Workstation.
3-13