Advertisement
6.2 Classes of the Device profile
The encoder class must be set when you configure the device.
See also the
Class 2 functionality
Class 1 allows basic functions of the device and can be used:
to send the position information (see the
to change the counting direction (see the
parameter);
to set the preset value (see the
Class 2 allows to use all Class 1 functions and further extended
functions, they are:
scaling function (see the
6.3 Operating modes
Profibus-DP devices allow operation using different communication
modes (see Figure below):
NOTE
All parameters are transmitted when the
the exception of the
Preset
value is transmitted only when the unit is in
mode.
Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: CustomerService@valin.com
operating parameter on page 32.
Preset
Scaling function
Power-ON
Set_Prm_FAIL
Chk_Cfg_FAIL
Wait_Prm
Wait_Cfg
Data_Exchang
Preset
value.
AMT58x-PB Profibus®
Position
parameter);
Code sequence
parameter).
parameter).
Init_OK
Set_Prm_O
K
Chk_Cfg_O
K
Set_Prm
mode is active with
Data_Exchange
29
Advertisement
