Datalogic AMT58-PB Series Instruction Manual page 47

6.8 "Red zone"
The so-called "red zone" occurs when:
Number of revolutions =
is NOT a power of 2.
When this problem arises, the device must operate within the "red
zone" for a certain number of positions. The size of the "red zone" is
variable. To calculate it we must subtract the
from the Hardware total resolution of the device as many times as
until the difference is less than the the set
When the encoder crosses the limit of the last
thus entering the "red zone", a counting error occurs, i.e. a jump in
the position count. The problem can be represented graphically in the
Figure below.
Example
25-bit resolution multiturn encoder
 Hardware counts per revolution
 Hardware number of revolutions
 Hardware total resolution
Set parameters values:

Counts per revolution

Total resolution
 Number of revolutions
Hardware number of revolutions
Set number of revolutions
Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: CustomerService@valin.com
AMT58x-PB Profibus®
Total resolution
Counts per revolution
Total resolution
Total resolution
Total resolution
= 8192 (2
= 4096 (2
= 33554432 (2
= 5000
= 10000000
= 2000
4096
=
2000
value
value.
section
13
)
12
)
25
)
= 2.048
41