Advertisement
4 - Electrical connections
WARNING
Electrical connection has to be carried out by qualified personnel
only, with power supply disconnected and mechanical parts
compulsorily in stop.
4.1 Connection cap
WARNING
Do not remove or mount the connection cap with power supply
switched ON. Damage may be caused to internal components.
The terminal connectors for connecting the power supply and the
BUS IN and BUS OUT cables as well as the dip-switches meant to
set the node ID and activate the termination resistance are located
inside the encoder connection cap. Thus you must remove the
connection cap to access any of them.
NOTE
Be careful not to damage the internal components when you perform
this operation.
To remove the connection cap loosen the two screws 1.
Please be careful with the internal connector.
Always replace the connection cap at the end of the operation.
Take care in re-connecting the internal connector. Tighten the screws
1 using a tightening torque of approx. 2.5 Nm.
WARNING
You are required to check that the encoder body and the connection
cap are at the same potential before replacing the connection cap!
Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: CustomerService@valin.com
AMT58x-PB Profibus®
7
Advertisement
