WAGO I/O-SYSTEM 750 Manual page 5

The integrated drivers of the end levels are temperature-monitored.
Both output channels have a common ground potential.
The output signal is electrically isolated from the system level and will be
output with a resolution of 16 bits.
The readiness for operation and the disturbance-free I/O module
communication of the module is indicated with one green function LED per
channel.
An overload or a short circuit of an output is indicated by one red error LED
per channel.
The calibration data is stored individually for each operating mode and can be
scaled. For the process data output, a lower and an upper limit value can be
specified.
Furthermore, a variety of adjustment possibilities can be made, including
calibration data switching, numeric format and numeric display switching,
output behavior for I/O module timeout, (repeat) switch-on delay after
excessive temperature switch-off, etc. The individual output modules can be
arranged in any combination when configuring the fieldbus node. An
arrangement in blocks is not necessary.
The internal system supply is used for the power supply. The field power
supply is only forwarded to the downstream I/O modules.
The system voltage is monitored for undervoltage.
The output module receives the 0 V potential and the 24 V for downstream
I/O modules via an upstream I/O module or via a supply module. Power
connections are made automatically from module to module via the internal
power jumper contacts when the output modules are snapped onto the DIN
rail.
Warning
The maximum current that is permitted to flow through the power jumper
contacts is 10A. When configuring the system, ensure that this total current is
not exceeded. If this should happen, an additional supply module has to be
used.
The output module can be operated on all couplers/controllers (with the
exception of the economy variants 750-320, -323, -324, and -327) of the
WAGO-I/O-SYSTEM 750.
WAGO-I/O-SYSTEM 750
I/O Modules
750-562 [2 AO 0/+-10V DC 16 Bit]
General Description
• 5