Resetting The Lens To Home Position; Selecting Screen Image Orientation; Adjusting On-Screen Display Menus; Determining The On-Screen Display Position - Christie HS Series User Manual

Resetting the lens to home position

Set the lens offset back to the home position.
1. Select Menu > Configuration > Lens Settings > Lens Calibration.
You can also press LENS on keypad or LENS H/LENS V on remote control.
2. To start the lens calibration, press ENTER.
3. To confirm the selection, select OK.

Selecting screen image orientation

Specify the orientation to use for the image. The projector supports front projection, rear
projection, front projection inverted, or rear projection inverted.
1. To invert the projection image, select Menu > Configuration > Ceiling Mount.
2. Select appropriate ceiling mount settings:
• Auto—Detect the orientation automatically.
• Off—Disable the ceiling mount setting.
• On—Enable the ceiling mount setting.
3. To confirm the image orientation, press ENTER.
4. To do a rear projection, select Menu > Configuration > Rear Projection.
5. To swap, press ENTER.

Adjusting on-screen display menus

Adjust various on-screen display (OSD) settings including the position, OSD transparency and
timing for OSD to disappear.

Determining the on-screen display position

Adjust the location of the on-screen display (OSD) menus.
1. Select MENU > Configuration > Menu Preferences > Menu Horz Offset or Menu Vert
Offset.
2. To determine the location on the screen where you want OSD to appear, adjust the slider by
arrow keys or press ENTER to input the value.
3. After inputting the value, press ENTER to apply.
4K7-HS/4K10-HS User Manual
020-001451-04 Rev. 1 (11-2019)
Copyright ©2019 Christie Digital Systems USA Inc. All rights reserved.
Configuring system settings
48