Swap Safety Card - Pilz PMCprotego S2-2 Operating Manual

Commissioning
7.3.3

Swap safety card

When swapping the safety card, please note the following:
}
If the firmware version has changed, configured functions and stated parameters may
no longer be supported or may have been modified. Adapt the configuration in the Con-
figurator PASconfig SDrive.
} You will need to download the configuration to the safety card again. Please note down
the serial number of the new safety card.
} We recommend that you swap the whole unit (servo amplifier with safety card). Please
contact Pilz.
After swapping the safety card, following a defect for example, you will need to download
the configuration data to the safety card again.
You can download the configuration data to the safety card as follows:
1
}
terface (RS 232 or Ethernet).
4
}
Operating Manual PMCprotego S2-2(-C)
1002529-EN-04
INFORMATION
Availability of this function: From firmware version 5.24 of the servo ampli-
fier.
NOTICE
Damage due to electrostatic discharge!
Electrostatic discharge can damage components. Ensure against discharge
before touching the product, e.g. by touching an earthed, conductive sur-
face or by wearing an earthed armband.
From the Configurator to the safety card via the servo amplifier's communications in-
From an SD card in the servo amplifier to the safety card.
62