Pilz PMCprotego S2-2 Operating Manual page 58

Commissioning
} SS1 Activate: Input for safety function SS1
}
Reset: Input for reset
}
STO Acknowledge: Output for feedback from safety function STO
}
Ready: Output for operating status of the safety card
}
"CONFIG" LED: Downloading the configuration data
} "RUN" LED: System is ready
}
RUN: System is ready for operation
} CONFIG: Downloading the configuration data
}
STARTUP: System starts up with the downloaded configuration
The inputs and outputs on the safety card can be tested using
}
The dynamic program display in the safety card's Configurator
}
the commissioning software PASmotion
Operating Manual PMCprotego S2-2(-C)
1002529-EN-04
1
SS1 Activate
0
1
Reset
0
1
STO Acknowledge
0
1
Ready
0
1
LED "CONFIG"
0
1
LED "RUN"
0
INFORMATION
Please note the following in the STARTUP state:
The activation inputs of all the safety functions configured in the tool must
be switched to +24 VDC.
RUN CONFIG STARTUP RUN
58