Device Management; Connecting To The Device - Siemens RUGGEDCOM RSG910C Installation Manual

Simatic net rugged ethernet switches
Hide thumbs

Advertisement

Table of Contents

Device Management

This section describes how to connect to and manage the device.
3.1

Connecting to the Device

The following describes the various methods for accessing the RUGGEDCOM
RSG910C console and Web interfaces on the device. For more detailed instructions,
refer to the RUGGEDCOM RSG910C User Guide for the RUGGEDCOM RSG910C.
IMPORTANT
Ethernet cables should be only be connected/disconnected in a non-hazardous area,
or when the device is not energized.
Console Port
Connect a workstation directly to the USB Type-B console port to access the boot-
time control and RUGGEDCOM RSG910C interfaces. The console port provides access
to RUGGEDCOM RSG910C's console interface.
IMPORTANT
Console ports are intended to be used only as a temporary connection during initial
configuration or troubleshooting.
Note
For Microsoft Windows users, the RUGGEDCOM USB Serial Console driver must be
installed on the users workstation before connecting via the USB Type-B console
port. For more information, refer to the RUGGEDCOM RSG910C User Guide for the
RUGGEDCOM RSG910C.
Use the following settings to connect to the port:
Speed
Data Bits
Stop Bit
Parity
Flow Control
Terminal ID
RUGGEDCOM RSG910C
Installation Manual, 02/2020, C79000-G8976-1405-06
57600 baud
8
1
None
Off
VT100
3
19

Advertisement

Table of Contents
loading

  Also See for Siemens RUGGEDCOM RSG910C

Table of Contents