Section H; Storage - USC LPX Operator's Manual

When storing the USC LPX Automated Seed Treater for long periods of time, the
following procedure must be followed to reduce the chance of rust, corrosion and
fatigue of the treater. You can also use these steps when storing the machine for
the winter.
A dust mask and protective rubber gloves shall be used when
cleaning the machine.
1. Turn power off to the treater and treater components.
2. Remove shields from the seed wheel and remove any debris or build-up.
Compressed air can be used to blow out any foreign material.
3. Turn power back on to the treater and run seed wheel to help remove any
additional debris. Compressed air can be used to blow out any foreign material.
4. Check brushes for wear (below).
5. Wipe off and clean the lens of the proximity switches (below).
6. Disconnect power and mount all guard back in place.
7. Tarp or cover the supply hopper and seed wheel to keep out any dirt or
unwanted pests
Proximity
Switch
LPX AUTOMATED SEED TREATER
SUPPLY HOPPER & SEED WHEEL
.
USC,

Storage

Storage
LLC
Section
Section
H
H
Brush
Page 69