USC LPX Operator's Manual page 34

LPX AUTOMATED SEED TREATER
Utilities Screen Button Descriptions
1. TARGET TREATING RATE:
Pressing this button allows the operator to adjust
the estimated treating rate in pounds per minute. This number is used by the
system to control the rate of the seed wheel and pumps.
2. PUMP PRE-START TIME:
Pressing this button allows the operator to adjust the
start time of the pumps after the "STARTUP" button has been pressed on the main
screen. This number will allow the air actuated 3-way valve to kick open and begin
sending liquid to the seed treater a certain number of seconds before the seed
wheel will turn on. This will help prevent any untreated seed at the beginning of a
run.
3. PUMP DELAY SHUT-OFF TIME:
Pressing this button allows the operator to
adjust the delay shut-off time of the pumps after the proximity switches located in
the seed wheel do not detect anymore seed.
4. INLET CONVEYOR DELAY RESTART TIME:
Pressing this button allows the
operator to adjust the restart time of the inlet conveyor after the top proximity switch
no longer detects seed.
5. TREATER SHUTDOWN TIME:
Pressing this button allows the operator to
adjust the delay shutdown time of the seed treater after the "SHUTDOWN" button
has been pressed after a run. This time will allow the seed treater and any
conveyor to completely clean out.
6. REPORTS:
This button advances the operator to the Reports screen.
7. PRODUCT SELECTION:
This button advances the operator to the Product
Selection screen.
8. SECURITY:
This button advances the operator to the Security screen.
9. ALARMS:
This button advances the operator to the Alarms screen.
10. Information:
This button advances the operator to the information screen
where the operator can find vital information on storage and troubleshooting.
Page 34 USC,
LLC