USC LPX Operator's Manual page 15

16. Have a certified electrician provide power to the seed
treating system. Provide convenient shutdown
switches, comply with local electrical codes and ensure
that the system is properly grounded and bonded. The
USC system must be connected to the same electrical
requirements as specified in the main control panel on
the power requirement tag, or the electrical schematic
shipped with the piece of equipment. This will power
the USC LPX seed treater and any attached conveyors.
17. A service port located on the side of the
main control panel will allow the operator
to connect a printer and an Ethernet
connection to the unit. The printer
connection will allow the user to print
reports directly from the reports screen.
Flexible conduit is
recommended for
main power supply.
18. Attach the communication cable from the pump stand control panel to the bottom
of the automated control panel (for an automated pump stand) or to the two-wire
plug on the bottom of the treater control panel (for a manual pump stand).
19. Provide 110V single phase power to both the main control panel and the pump
stand(s).
20. Reverse the previous steps when removing the machine from its working position.
LPX AUTOMATED SEED TREATER
USC,
Printer
Connection
LLC
Ethernet
Connection
Page 15