USC LPX Operator's Manual page 32

LPX AUTOMATED SEED TREATER
H-O-A Button Descriptions
11. "PRIME TO ATOMIZER" Button:
Used before a controlled startup to "preload"
chemical in the tubing leading to the atomizer. To operate this button, place the
atomizer and any pump that will be used in the "AUTO" mode. Next press and hold
the "PRIME TO ATOMIZER" button. The atomizer and pumps will turn on and the
liquid will be directed to the atomizer. The atomizer and pumps will run as long as
the button is being pressed. When the button is released the atomizer and pumps
will shut-off.
12. Air Valve Control Module:
This module controls where liquid is diverted for
each pump. When a desired pump is placed in the "HAND" mode, the "RECIRC."
button will appear next to that pump control module. In this mode, liquid is pumped
out of its desired tank, through the air actuated 3-way valve manifold and back into
the mix tank. When the "RECIRC." button is pressed, the icon will change to
"PROCESS". In this mode, liquid is diverted from the air actuated 3-way valve, to the
atomizer. When the "OFF" button is pressed the pump will go back to "RECIRC."
When the pump is placed in the "AUTO" mode the Air Valve0 Control cannot be
accessed.
13. "REVERSE" Button:
Allows the operator to reverse the pump direction and
pump the product back into the mix tank. When the pump is in Hand or Auto mode,
this button will become a display for the actual pump flow rate.
14. Pump Percent Speed:
When these
buttons are pressed, a numeric touch pad
(right) will appear to allow the operator to
manually adjust the speed of the pump(s).
Page 32 USC,
LLC