USC LPX Operator's Manual page 47

4. When the pump's flow rate has been reached and seed is covering the proximity
sensors inside of the seed wheel, the air actuated 3-way valve will open and
allow liquid to pump up to the atomizer. A moment later (based on the settings
in the utilities screen), the seed wheel will turn on and the seed treating process
will begin.
5. As the seed is being treated. The main screen will display the pounds per
minute, the total pounds, and the liquid flow rate. If the system needs to be
stopped for a moment because of a problem. The "PAUSE" button can be
pressed to halt the process. When ready to begin again, the "CONTINUE"
button is pressed.
6. When the seed wheel hopper is full the "HOPPER FULL" indicator light will come
on and the inlet conveyor will shut off. The flow of seed into the treater will begin
again once seed is no longer present at the top proximity sensor in the hopper.
This is done to ensure that seed will not overfill the hopper and flow onto the
ground.
LPX AUTOMATED SEED TREATER
Pause Button
USC,
LLC
Page 47