Transmitter General Specifications - Oval ALTI mass Series Instructions Manual

L-770HP--E

3.2 Transmitter general specifications

Item
Transmitter model
Connected detector
Power supply
Power consumption
Ambient temperature
Transmission distance (※)
Dust-water-proof structure
Mounting structure
Transmitter structure
Weight
Display / Operation
Communication type
Analog output
Pulse output
Status input/
Status output
Explosion-proof
specification /
Applicable guidelines
Applicable standards
NOTES ※: Please consult OVAL sales office or nearest representative when it exceeds the maximum transmission distance.
Working temperature range of dedicated cables (PVC: model CBP) is between - ℃ and +0℃.
When using in an environment exceeding this temperature range, please use dedicated cables(Teflon: model
CBT).
※: Type S stainless-steel tube type does not comply with the density output.
Volume output uses fixed density compensation.

PAK
Coriolis flowmeter ALTImass series detector
AC-powered: AC 00V to 0V 0/0Hz (Allowable voltage range: AC V to V)
DC-powered: DC 0V to 0V (Recommended DC power supply capacity: VDC, A or over)
Max VA, 7W
－ 0 to +0℃
Type U: Max 00m (Max 00m for CA00A and CA00)
Type S: Max 00m (Titanium), Max 0m (Stainless steel)
Type B: Max 0m
(All of these types are connected with dedicated -core cables.)
IP0
Rack mounting type (installation in a non-dangerous place)
Case material: steel plate
Coating color : black
0.kg
LED for operation status display:  (red and green), zero adjustment button
HART communication
(standard type)
Modbus communication
type
 systems
-0mA, load resistance 00 Ω or less (0 Ω or over when using the HART
communication
Select from mass flowrate, volume flowrate, temperature, density or drive gain
current output. ( ※ )
 system, maximum frequency: ,000Hz, pulse width duty 0%
Open drain output (equivalent to open collector output) [Max 0V, 0mA]; or
Voltage pulse "Low Level": .V or less, "High Level": V or over
Output impedance: .kΩ
Select one point from Status input / Status output.
Input
Output
Refer to P. for details of TIIS and IECEx (we are currently preparing
for ATEX).
EMC
Product safety
Description
Superimposed to the HART 7 Analog
Output 
RS- Modbus protocol
※Analog output cannot be used with the
Modbus communication type.
Contact point input (input at the contact point a)
Close: 00Ω or less, Open: 00kΩ or over
Select from Integrated value reset, Zero adjustment or Fix to
output 0%.
Open drain output (equivalent to open collector output)
[Max 0V, 0mA]
Select from Error (standard), Inflow direction, Zero
adjustment in progress, High/Low alarm, or Without
function.
EN -
EN 00- (Overvoltage Category: II, Pollution degree:
, Installation altitude: 000m or below)